(+81) 50 5806 8838

Welcome to EasyCNC Shopping!

Glossary

  • 1-2-3 Block - A precision ground block that is 1x2x3 inches. Useful for helping set up the machine.
  • 2D - A prismatic part of constant thickness.
  • 2-½ D - A prismatic part with multiple thicknesses. All planes are parallel to each other.
  • 3D - A part that is not completely prismatic, including molds and organically shaped parts.
  • Burr - A sharp edge or flashing.
  • Block - A line of code in a CNC program.
  • CAD - Computer Aided Design
  • CAM - Computer Aided Manufacturing.
  • CDC - Cutter Diameter Compensation.
  • CNC - Computer Numerical Control.
  • Chip Load - The amount of material removed with each pass of a tool cutting edge.
  • Datum - Point on the part from which all coordinates are referenced.
  • Drill Chart - A table that shows drill sizes, their decimal equivalent, and what size drill to use for a specified tap.
  • Feed - The linear speed at which a tool advances through material.
  • First Article - The first part machined with a new program and setup.
  • G-M Code - The CNC machine tool language.
  • Gouge - An error that causes an overcut on the part.
  • High Speed Machining (HSM) - Toolpath strategies that minimize machining time and tool breaking. Includes several technologies such 
  • as Adaptive Roughing that maintain a constant amount of tool engagement.
  • Home - Location of machine after it is turned on and moved to its start position.
  • ID - Inside diameter or contour, like a pocket.
  • Insert - Carbide composite cutting tool used extensively for turning operations.
  • Job - A sequential list of one or more machining operations that share the same setup and fixture offset.
  • Machine Coordinate System - Coordinates in reference to the machine Home position.
  • Mill - A machine tool that removes material by spinning a tool and moving it in relation to the part.
  • OD - Outside diameter or contour.
  • Overcut - Describes a machined feature is too big because not enough material was removed during machining.
  • Post Processor - The part of a CAD/CAM system that actually creates and formats the CNC program for a specific machine and control.
  • Rapid - The fastest linear feed rate at which a machine tool can move.
  • Reference Point - Some point on the part that can be found reliably by mechanical means.
  • Rigid Tapping - The capability of a CNC machine to control a tap without the use of a special tapping attachment.
  • Scallop - Ridges left on the part, usually from a ball or bull nose end mill on a 3D sculpted surface.
  • Setup- A complete set of work holding to machine one side of a part.
  • Speed - How fast a tool turns in RPM.
  • Spindle - Part of CNC machine that grips and spins the cutting tool.
  • Stepdown - Distance the tool moves down in Z between machining passes.
  • Stepover - Distance the tool moves over in the XY plane between machining passes.
  • Stock Allowance - Amount of material left after a machining operation or pass to be removed by a finish pass.
  • Spring Pass - Two or more machining passes that follows the exact same path. Used to straighten walls and improve surface finish.
  • TLO - Tool Length Offset. Used to tell CNC machine the length of a tool.
  • Tool Changer - A device on a CNC machine that automatically takes tools from a carousel and places them in the machine spindle.
  • T-Slot - A slot in the machine table into which a special T-nut can be inserted. Used to fasten clamps or parts to the machine table.
  • Turret - Lathe assembly that attaches the lathe tool holder to the machine.
  • Undercut - Describes a machined feature is too small because too much material was removed during machining.